Lyntec > Products > AC Power Control > DMX Home > Lighting Control Relay Panel_LCRP Series

LCRP Series Relay Boxes

Add Circuit Control to Any Existing Breaker Panel!

Perfect for Retrofit Applications!


Individual Circuit Control via DMX512 protocol

  • Tested, complete package — low labor — mount next to circuit breaker panel to control AC power "hot" lines
  • Time proven, reliable, G-E RR7P3 latching relays snap in and have low voltage plug-in connectors
  • Low power consumption — no continuous relay coil current — runs cool for long life
  • Diagnostic LEDs and internal ON -OFF test switches speed installation for testing and troubleshooting
  • Cabinet and all components connected to high voltage are ULlisted — Electrician friendly
  • 4, 8 or 10 circuits — 120, 240 or 277volt models available
  • Daisy-chains for unlimited circuitcount
  • Automatic load shedding and brownout protection.
  • Built-in emergency override function
 

LCRP-4:   4 relays

LCRP-8:   8 relays

LCRP-10: 10 relays

LC-10 Series

Each motorized breaker is DMX512 addressable via a simple set of jumpers on the LynTec control board. Once the DMX address starting point is set by inserting the jumper, each motorized breaker has the next sequential address assigned to it (one address per breaker), the DMX operator can then program the breaker addresses for individual control. The LynTec control boards only use as many addresses as there are motorized breakers connected to it, this saves valuable DMX addresses for other equipment. DMX commands for each breaker are on, off or no change.

 

Move your mouse over the red dots Red-Dot.gif to see all of the great features.

You must install Adobe Flash to view this content.

G-E RR7 and RR9 Relay ratings

Power Contacts: Latching

  • 20A Tungsten, 125Vac 1/2HP motor at 110-125Vac
  • 30A Ballast, 277Vac 1 1/2 HP motor at 277Vac
  • 30A Resistive, 277VAC
  • 20A Ballast, 347VAC 1 1/2 HP motor at 220-277VAC
  • 20A Resistive, 347Vac

FOR COPPER WIRE ONLY

This product is NEC 110 Compliant when used in accordance withthe following: Suitable For Use On A Circuit Capable Of Delivering Not More Than 10 kA Sym. Amps., 277 Volts Maximum.UL Listed 508G Industrial Control Equipment — CSA certified

Low voltage characteristics — RR7P3 P3 suffix denotes a 3 pin, .156" AMP or Molex connector attached.

RR9P has a five pin connector.  Actuating coils: 21-30 Vac (class 2) Momentary. OFF (1-black),ON (2-red), Common (3-Blue) 55-60 Ohms DCR, each coil.

LCRP Brochure