LCRP

Retrofit DMX Lighting Control Relay Panel

  • Tested, complete package — low labor — mount next to circuit breaker panel to control AC power “hot” lines
  • Reliable Panasonic latching in modules of 4 relays for easy expansion
  • Low power consumption — no continuous relay coil current — runs cool for long life
  • Diagnostic LEDs and internal ON -OFF test switches speed installation for testing and troubleshooting
  • Cabinet and all components connected to high voltage are ULlisted — Electrician friendly
  • 4, 8 or 12 circuits — 120, 240 or 277volt models available
  • Daisy-chains for unlimited circuit count control
  • DMX 512 control standard in all panels, a simple jumper system sets your addressing
  • Control circuits individually or in zoned group
  • Simplest control set-up and operation in the industry
  • No on-site commissioning or factory start-up required
  • Emergency auto-on feature for egress lighting standard (ETL listed UL 924)
  • Saves Space
  • Saves redundant installation and hardware costs!
  • Energy efficient – NO holding current or heat sinks required to maintain state – Runs cool, lasts long!
ETL_Safety

LC-12 Series


Each motorized breaker is DMX512 addressable via a simple set of jumpers on the LynTec control board. Once the DMX address starting point is set by inserting the jumper, each motorized breaker has the next sequential address assigned to it (one address per breaker), the DMX operator can then program the breaker addresses for individual control. The LynTec control boards only use as many addresses as there are motorized breakers connected to it, this saves valuable DMX addresses for other equipment. DMX commands for each breaker are on, off or no change.

Relay

Panasonic Relays

  • 30A Tungsten, 125Vac 1/2HP motor at 110-125Vac
  • 30A Ballast, 277Vac 1 1/2 HP motor at 277Vac
  • 50A Resistive, 277VAC
  • 30A Ballast, 347VAC 1 1/2 HP motor at 220-277VAC
  • 50A Resistive, 347Vac

FOR COPPER WIRE ONLY

This product is NEC 110 Compliant when used in accordance withthe following: Suitable For Use On A Circuit Capable Of Delivering Not More Than 10 kA Sym. Amps., 277 Volts Maximum.UL Listed 508G Industrial Control Equipment — CSA certified